When the set first turns on, it enters the First Time Installation mode. This can be restarted by restoring the set to default settings in the ‘ABOUT TV’ menu
Languages
Select your preferred on-screen display language. This will change the language in which the menus and associated information is displayed. To change this press the [MENU] button and then select Settings > System Menu > Language
Agreement 1
Agree to the Data Collection and Firmware update notice.
Agreement 2
Agree to the manufacturers’ Terms of Use. (Only applicable to Freeview Play sets.)
Country Selection
Select the correct flag for the country in which the set will be used. This will enable the set to correctly install the functions applicable to the country of use.
Environment of Use
Home Mode: For normal use, by default, it is set to a power saving mode which reduces the energy used by up to 25% (by reducing the power to the LED/LCD panel). This can be changed in the picture mode settings.
Network setup
You can connect the TV to your broadband router or wireless network in order to take advantage of the Smart functions. If you connect the TV to your router using an Ethernet cable (recommended) this step will be skipped.
Select Wi-Fi Network
Select the Wi-Fi network which you would like to be connected to. A padlock symbol next to the network indicates that it will require a password to use.
Entering Password
Use the arrow buttons on the remote control to select the correct character and then press [OK] to enter. Press the [GREEN] button to reveal the password.
Confirmation of Internet Connection
If the network has been correctly authorised, a tick symbol will appear next to it.
Set Up Netflix
If you have a Netflix account, it can be set up on the television here. Once set up and validated, the First Time Installation continues on to the next step.
Default Source
Select the source which you use the most. If Digital TV (Freeview) is chosen, then at the next step, the set will tune in and default to Digital TV (Freeview). If one of the other sources is selected, then the set will not tune in at this stage and default to that input. To change this press the [MENU] button and then select Settings > Channel
Tune in Channels
Chose to install terrestrial channels now or later.
Support Advice
Information regarding support is displayed.
Tuning Progress Indication
Tuning continues and a progress bar is shown with the number of channels found indicated below this.
Country Selection
When Digital tuning is complete, select your country of use. Normally this will only show one country, unless you are receiving channels from multiple transmitters in other countries.
Primary Region Selection
Select the region that you would like to receive your local news from.
Secondary Region Selection
Select your nearest or strongest signal transmitter.
Note These screens only come up if more than one region is found. i.e. two or more transmitters are
tuned in.
Note:
In Home Mode, the TV will switch itself to the standby mode after 4 hours in the event that the buttons on the remote control or TV set are not used. This can be disabled in the ‘TIME’ menu.
Store Mode: For store display use. The picture is adjusted to optimum settings. The store demonstration will appear on the screen automatically after two minutes.
